Today, I have been continuing to work on two plates; a Linocut based on a Vernon Park and an etching of The Blossoms pub.

I started work on the linocut this morning by removing small sections all over the linoleum sheet in preparation for a new layer colour. I decided to add a mix of burnt umber, white and yellow to create a sandy colour. I reckon I have at least 2 more colours left to print which I will be adding soon which will be light green ink for the foliage and highlights on the bench possibly white ink.

After lunch, I continued to work on another print this time an etching depicting The Blossoms pub. One issue from last time working on this print is that I discovered while printing a proof of the etching, there was a white spot on the print where the aquatint had for some reason been removed. As you can see in the photo below of the test print, this was very noticeable on the print, so I had to remedy this before I could continue printing.

‘The Blossoms’ (Etching Aquatint)

I added aquatint resin again to the plate and then using stop out, I covered all the plate apart from the section where the blemish was located. The dark section on the print is where I left the plate exposed to the strong acid for 5 minutes. I then printed another proof and the result is shown in the photo below.

I then worked on burnishing the plate to lighten areas where required. In my next blog post I will show the finished print.